ASTM E2491 PDF

Originally contact ASTM Customer Service at [email protected] For Annual Book of ASTM approved in Last previous edition approved in as E This standard is issued under the fixed designation E; the number 1 This guide is under the jurisdiction of ASTM Committee E07 on Nondestruc-. The PH Tool ASTM E Phased Array Assessment Block is a general purpose Phased Array calibration block used for beam characterization and evaluation.

Author: Kazraran Maukinos
Country: Sudan
Language: English (Spanish)
Genre: Politics
Published (Last): 7 April 2015
Pages: 240
PDF File Size: 18.72 Mb
ePub File Size: 7.75 Mb
ISBN: 691-2-22781-917-4
Downloads: 93585
Price: Free* [*Free Regsitration Required]
Uploader: Kagaramar

It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

Referenced Documents purchase separately The documents listed below are referenced within e241 subject standard but are not provided as part of the standard.

This standard does not purport to address all of the safety concerns, if any, associated with e2941 use. This guide is not intended to be used as a substitute for calibration or standardization of an instrument or system to inspect any given material. All or portions of the guide may be used as determined by the user.

  ANALYSIS TECHNIQUES FOR RACECAR DATA ACQUISITION JORGE SEGERS PDF

Other electronic instrument characteristics in phased-array units are similar w2491 non-phased-array units and may be measured as described in E or E Historical Version s – view previous versions of standard.

It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Link to Active This link will always route to the current Active version of the standard.

This guide is not intended to be used as a substitute for calibration or standardization of an instrument or system to inspect any given material. It is intended for phased-array flaw detection instruments operating in the nominal frequency range of 1 MHz to 20 MHz, but the procedures are applicable to measurements on instruments utilizing significantly higher frequency components.

Instrument characteristics measured in accordance with this guide are expressed in terms that relate e22491 their potential usefulness for ultrasonic examinations. Active view current version of standard.

ASTM E TYPE B PHASED ARRAY ASSESSMENT BLOCK, STEEL – NDT

No other units of measurement are included in this standard. Referenced Documents purchase separately The documents listed below are referenced within the subject standard but are not provided as part of the standard. Link to Active This link will always route to adtm current Active version of the standard.

  FORMAS BREVES RICARDO PIGLIA PDF

It is not intended to define performance and acceptance criteria, but rather to provide data from which such criteria may be established. Instrument characteristics measured in accordance with this guide are expressed in terms that relate to their potential usefulness for ultrasonic examinations.

Other electronic instrument characteristics in phased-array units are similar to non-phased-array units and may be measured as described in Practice E or Guide E Where acceptance criteria are implied herein they are for example only and are subject to more or less restrictive limits imposed by customers and end users controlling documents.

Author: admin